Docol® Tube 600LA is high-strength formable precision tube with pickled hot rolled surface condition. Available in circular, rectangular and square shapes. Customized shapes and other tailoring options are available upon request. Typical uses include automotive and engineering, where durability, formability, lightness and energy absorption are important.
Docol Tube 600LA is available in circular, square and rectangular shapes.
Other shapes, sizes and lengths are available upon request.
HR600LA
Mechanical properties meet the requirements of EN 10305 (+CR2).
HR600LA
Chemical composition meets the requirements of EN 10305.
If other chemical elements such as Ti, Nb or V are used, the content of these elements are reported in the inspection document.
1) This requirement is not applicable provided the steel contains a sufficient amount of other nitrogen binding elements, such as Ti, Nb or V.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
Surface is slightly oiled to protect it from corrosion during transportation and short-term storage. By request, tubes can be delivered dry, however in that case SSAB will not be responsible for any possible rust.
The tubes are not intended to undergo any heat treatment after welding and sizing as that may alter the mechanical properties of the material.
The tubes are oiled with anti-corrosive oil.
For information concerning fabrication, see SSAB´s brochures on www.ssab.com or consult Tech Support.
Appropriate health and safety precautions must be taken when bending, welding, cutting, grinding or otherwise working on the products.