Docol®Tube 590DP is high-strength formable precision tube made from dual-phase steel with high tensile strength and very good formability. Available in circular, rectangular and square shapes, it comes with different coating and surface options including cold rolled (uncoated), galvanized, galvannealed and galfan. Customized shapes and other tailoring options are available upon request. Typically used in automotive industry where durability, formability and energy absorption are important.
Docol Tube 590DP is available in circular, square and rectangular shapes.
Other shapes, sizes and lengths are available upon request.
CR500Y590T-DP
CR500Y590T-DH
CR500Y590T-DP
CR500Y590T-DH
Chemical composition meets the requirements of VDA 239-100.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
1)For a maximum distance of 100 mm, the ends may, due to the cutting method, have diameters outside the tolerances.
Surface is slightly oiled to protect it from corrosion during transportation and short-term storage. By request, tubes can be delivered dry, however in that case SSAB will not be responsible for any possible rust.
1) Theoretical guidance values for coating thickness per surface.
2) Minimum coating mass - g/m2 refers the coating mass for each side in g/m2 according to VDA 239-100.
3) Minimum coating mass - g/m2 refers the total weight of coatings on both sides of a 1 m2 plate.
The tubes are not intended to undergo any heat treatment after welding and sizing as that may alter the mechanical properties of the material.
The tubes are oiled with anti-corrosive oil.
For information concerning fabrication, see SSAB´s brochures on www.ssab.com or consult Tech Support.
Appropriate health and safety precautions must be taken when bending, welding, cutting, grinding or otherwise working on the products.